Server Technology PT40 Manual de instalación descargar pdf (Pagina 79)

Smart Cabinet Distribution Unit Appendices • 79

Installation and Operations Manual

Chapter 5: Appendices

Appendix A: Resetting to Factory Defaults

You may reset the non-volatile RAM that stores all configurable options. This clears all administrator-

editable fields and resets all command line configurable options to their default values, including all

user accounts.

You may reset the unit to factory defaults from the command line or the HTML interface, or by

pressing the reset button. You must have administrator-level privileges to issue the command. Using

the reset button may be necessary when a forgotten password prevents administrator login. Each of the

methods updates the current working configuration to the factory defaults.

NOTE: Resetting the unit resets all TCP/IP and Telnet/Web configurations. Reconfiguring the TCP/IP and Telnet/web

settings will be required.

To reset to factory defaults from the HTML interface

On the Restart page in the Tools section of the HTML interface, select Restart and reset to factory

defaults from the drop-down menu and press Apply.

To reset to factory defaults from the command line

At the Smart CDU: prompt, type restart factory and press Enter.

To reset to factory defaults using the reset button

Locate the recessed reset button directly beside the Serial & Ethernet ports. You will need a non-

conductive, non-metallic tool that fits inside the recess.

NOTE: This method will NOT work if the reset button has been disabled by the administrator.

Insert the tool in the recess, then depress and hold the reset button for at least ten seconds.

NOTE: If the reset button is depressed and held for more than 15 seconds, the reset will abort.

Appendix B: Uploading Firmware

You may upload new versions of firmware using File Transfer Protocol (FTP). This allows access to

new firmware releases for firmware improvements and new features additions.

NOTE: To begin an FTP upload session, you must first configure the FTP Host address, username/password, filename and

filepath. For information on configuring the FTP settings required for firmware upload see Chapter 3: Operations.

You may initiate an FTP upload session by issuing a command or from the HTML interface. You must

have administrator-level privileges to initiate an upload.

To initiate an FTP upload session from the HTML interface

On the Restart page in the Tools section of the HTML interface, select Restart and upload firmware

via FTP from the drop-down menu and press Apply.

Upon issuing this command the unit will restart and upload the firmware file specified with the FTP

Filename command from the previously configured FTP Host. See

FTP Administration in Chapter 3:

for more information.

To initiate an FTP upload session from the command line

The Restart FTPLoad command initiates an upload of firmware. Upon issuing this command the unit

will restart and upload the firmware file specified with the FTP Filename command from the previously

configured FTP Host. See

FTP Administration in Chapter 3: for more information.

To initiate an FTP firmware upload session:

At the Smart CDU: prompt, type restart ftpload and press Enter.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 89 90

Comentarios a estos manuales

Sin comentarios

Server Technology PT40 Manual de instalación Pagina 79

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Server Technology PT40