Server Technology PT40 Manual de instalación descargar pdf (Pagina 41)

Smart Cabinet Distribution Unit Operations • 41

Installation and Operations Manual

Telnet Administration

NOTE: A restart of the Sentry is required after setting or changing ANY Telnet/Web configurations. See Performing a

warm boot on page 39 for more information.

Enabling and disabling Telnet support:

The Set Telnet command is used to enable or disable Telnet support.

To enable or disable Telnet support:

At the Smart CDU: prompt, type set telnet, followed by enabled or disabled and press Enter.

Changing the Telnet port:

With Telnet support enabled, the Telnet server watches and responds to requests on the default Telnet port

number 23. This port number may be changed using the Set Telnet Port command.

To change the Telnet socket:

At the Smart CDU: prompt, type set telnet port, followed by the port number and press Enter.

Example

The following changes the Telnet port number to 7001:

Smart CDU: set telnet port 7001<Enter>

FTP Administration

You may upload new versions of firmware into the Sentry using File Transfer Protocol (FTP). This

allows access to new firmware releases for firmware improvements and new features additions. The

following commands are used to configure the Sentry for an FTP firmware upload. See

Appendix B:

Uploading Firmware for more information on initiating a FTP firmware upload.

Setting the FTP host address:

The Set FTP Host command sets the FTP host IP address or hostname allowing for firmware file uploads.

To set the FTP Host address:

At the Smart CDU: prompt, type set ftp host, followed by the IP address or hostname and press Enter.

Examples

The following command sets the FTP host IP address to 12.34.56.99:

Smart CDU: set ftp host 12.34.56.99<Enter>

The following command sets the FTP hostname to ftp.servertech.com:

Smart CDU: set ftp host ftp.servertech.com<Enter>

Setting the FTP username:

The Set FTP Username command sets the username as required by the FTP Host.

To set the FTP username:

At the Smart CDU: prompt, type set ftp username, followed by the FTP username and press Enter.

Example

The following command sets the FTP username to Guest:

Smart CDU: set ftp username guest<Enter>

Setting the FTP Password:

The Set FTP Password command sets the password as required by the FTP Host.

To set the FTP password:

At the Smart CDU: prompt, type set ftp password, followed by the FTP password and press Enter.

Example

The following command sets the FTP password to OpenSesame:

Smart CDU: set ftp password OpenSesame<Enter>

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 89 90

Comentarios a estos manuales

Sin comentarios

Server Technology PT40 Manual de instalación Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Server Technology PT40