Server Technology PT40 Manual de instalación descargar pdf (Pagina 53)

Smart Cabinet Distribution Unit Advanced Operations • 53

Installation and Operations Manual

SNMP/Thresholds

The Sentry family of products supports the Simple Network Management Protocol (SNMP). This

allows network management systems to use SNMP requests to retrieve information and control power

for the individual outlets.

The Sentry includes an SNMP v2c agent supporting standard MIB I and MIB II objects. A private

enterprise MIB extension (Sentry3 MIB) is also supported to provide remote power control.

See

SNMP on page 20, for information on enabling and configuring SNMP.

NOTE: For security, SNMP support is disabled by default.

SNMP Command Summary

Command Description

Set SNMP Enables or disables SNMP support

Set SNMP Getcomm Sets the ‘get’ community string

Set SNMP Setcomm Sets the ‘set’ community string

Set SNMP Trapdest Sets a destination IP address or hostname for traps

Set SNMP Traptime Sets the delay for steady state condition traps

Set SNMP IPRestrict Allows SNMP GET and SET requests from defined traps destinations only

Show SNMP Displays all SNMP configuration information

MIB, OID and Support

The Sentry SNMP MIB and OID are available on the Server Technology website:

ftp://ftp.servertech.com/pub/SNMP/sentry3

Technical support is available 8:00AM to 5:00 PM Pacific Time, Monday-Friday.

For SNMP Support, email: [email protected]

Enabling and Setting up SNMP Support

Sentry SNMP support must be enabled and configured for access to Sentry3 MIB objects and

generation of all Sentry3 traps.

Enabling/disabling SNMP support:

The Sentry SNMP command is used to enable or disable SNMP support.

To enable SNMP support:

At the Smart CDU: prompt, type set snmp, followed by enabled or disabled and press Enter.

NOTE: A restart of the Sentry is required after enabling or disabling SNMP support. See Performing a warm boot on

page 39 for more information.

Setting trap destinations:

The Set SNMP Trapdest1 and Trapdest2 commands are used to set the IP addresses or hostname of

SNMP management stations receiving all traps. Sentry supports a maximum of two trap destinations;

one must be defined to enable trap generation.

To set the trap destination:

At the Smart CDU: prompt, type set snmp, trapdest1 or trapdest2, the Ipaddress or hostname and

press Enter.

Examples

The following sets the trap destination 1 to 64.42.31.208:

Smart CDU: set snmp trapdest1 64.42.31.208<Enter>

The following sets the trap destination 2 to snmp.servertech.com:

Smart CDU: set snmp trapdest2 snmp.servertech.com<Enter>

To reset the trap destination:

At the Smart CDU: prompt, type set snmp, trapdest1 or trapdest2, 0.0.0.0 and press Enter.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 89 90

Comentarios a estos manuales

Sin comentarios

Server Technology PT40 Manual de instalación Pagina 53

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Server Technology PT40