Server Technology PT40 Manual de instalación descargar pdf (Pagina 39)

Smart Cabinet Distribution Unit Operations • 39

Installation and Operations Manual

Performing a warm boot:

The Restart command performs a warm boot of the Sentry.

NOTE: System user/outlet/group/port configuration or outlet states are NOT changed or reset with this command.

To perform a warm boot:

At the Smart CDU: prompt, type restart and press Enter.

TCP/IP Administration

NOTE: A restart of the Sentry is required after setting or changing ANY TCP/IP configurations. See Performing a warm

boot on page 39 for more information.

Enabling or disabling DHCP support:

The Set DHCP command enables or disables DHCP support.

To enable or disable DHCP support:

At the Smart CDU: prompt, type set dhcp, followed by enabled or disabled and press Enter.

Setting the IP address:

The Set IPAddress command sets the TCP/IP address of the network interface controller.

To set the IP address:

At the Smart CDU: prompt, type set ipaddress, followed by the IP address and press Enter.

Example

The following command sets the IP address to 12.34.56.78:

Smart CDU: set ipaddress 12.34.56.78<Enter>

Setting the subnet mask:

The Set Subnet command sets the subnet mask for the network the PT40 will be attached to.

To set the subnet mask:

At the Smart CDU: prompt, type set subnet, followed by the subnet mask and press Enter.

Example

The following command sets the subnet mask to 255.0.0.0

Smart CDU: set subnet 255.0.0.0<Enter>

Setting the gateway:

The Set Gateway command sets the IP address of the default gateway the Sentry uses to access external

networks.

To set the gateway IP address:

At the Smart CDU: prompt, type set gateway, followed by the gateway IP address and press Enter.

Example

The following command set the gateway IP address to 12.34.56.1:

Smart CDU: set gateway 12.34.56.1<Enter>

Setting the DNS IP address:

The Set DNS command sets the TCP/IP address of the Domain Name server (DNS).

To set the DNS IP address:

At the Smart CDU: prompt, type set, followed by dns1 or dns2 and the Domain Name server’s IP

address. Press Enter.

Example

The following command sets the primary Domain Name server IP address to 98.76.54.254:

Smart CDU: set dns1 98.76.54.254<Enter>

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 89 90

Comentarios a estos manuales

Sin comentarios

Server Technology PT40 Manual de instalación Pagina 39

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Server Technology PT40