Server Technology PT40 Manual de instalación descargar pdf (Pagina 15)

Smart Cabinet Distribution Unit Operations • 15

Installation and Operations Manual

Creating a descriptive Environmental Monitor name:

Click on the Environmental Monitor Names link.

On the subsequent Environmental Monitor Names page, enter a descriptive name and press Apply.

Creating descriptive sensor names:

Click on the Sensor Names link.

On the subsequent Sensor Names page, enter a descriptive name and press Apply.

Network

The Network configuration page is used for maintenance of the network interface. From this page an

administrator may configure the IP address, subnet mask, gateway address, DNS addresses as well as

view the link status, speed and duplex value.

The Sentry is configured with the following network defaults to allow unit configuration out-of-the-box

through either Telnet or HTML:

• IP address: 192.168.1.254

• Subnet Mask: 255.255.255.0

• Gateway: 192.168.1.1

The initial local PC network connection must be configured as noted below:

NOTE: Contact your system administrator for instructions in reconfiguring the network connection. Reconfiguration of

your network connection may require a restart to take effect.

• IP address: 192.168.1.x (where x is 2-253)

• Subnet Mask: 255.255.255.0

NOTE: The unit must be restarted after network configuration changes. See Performing a warm boot: on page 24.

Enabling or disabling DHCP support:

Select Enabled or Disabled from the DHCP drop-down menu and press Apply.

Setting the IP address, subnet mask, gateway or DNS address:

In the appropriate field, enter the IP address, subnet mask, gateway address or DNS address and press Apply.

Telnet/SSH

The Telnet/SSH configuration page used to enable or disable Telnet and SSH support and configure the

port number that the Telnet or SSH server watches. For more information on SSH see page

51 in

Chapter 4: Advanced Operations.

Enabling or disabling Telnet or SSH support:

Select Enabled or Disabled from the appropriate Server drop-down menu and press Apply.

Changing the Telnet or SSH server port number:

In the appropriate Port field, enter the port number and press Apply.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 89 90

Sin comentarios

Server Technology PT40 Manual de instalación Pagina 15