Server Technology PT40 Especificaciones descargar pdf (Pagina 37)

Setting the LED display orientation

The Set Display command is used to configure the Current LED(s) display orientation.

To set the LED display orientation:

At the Sentry: prompt, type set display, followed by normal or inverted and press Enter.

Example

The following set the LED display orientation to Inverted:

Sentry: set display inverted<Enter>

NOTE: When set to Inverted, the load will be reported in whole ampere increments

Displaying system configuration information

The Show System command displays all system configuration information.

• Firmware version

• NIC module serial number and MAC address

• Hardware revision code and Flash size

• Uptime since last system restart

• System location description

See Chapter 4: Advanced Operations on page 43 for more information on SNMP.

To display system configuration information:

At the Sentry: prompt, type show system and press Enter.

Example

System Information

F/W Version: Sentry Version 5.2b

NIC S/N: 1600001

MAC Address: 00-0a-9c-10-00-01

H/W Rev Code: 0

Flash Size: 1 MB

Uptime: 0 days 6 hours 14 minutes 1 second

Location: Florida HQ

Creating a descriptive tower name

The Set Tower Name command assigns a descriptive name to a tower. This descriptive name is

displayed when the Show Traps command is issued. See Displaying trap configuration information on

page 38 for more information on the Show Traps command.

To create a tower name:

At the Sentry: prompt, type set tower name, followed by the absolute tower name, then the descriptive

name of up to 24 alphanumeric and other typeable characters (ASCII 33 to 126 decimal - spaces are not

allowed). Press Enter.

Example

The following command adds the descriptive name Florida_HQ_1 to tower .a:

Sentry: set tower name .a Florida_HQ_1<Enter>

Displaying tower information

The Show Towers command displays information about the Sentry. This information includes the

absolute and descriptive Sentry names.

To display tower information:

At the Sentry: prompt, type show towers and press Enter.

Example

Sentry: show towers<Enter>

Tower Tower

ID Name

.A Florida_HQ_1

Sentry Commander - PT40 Operations • 37

Installation and Operations Manual

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 73 74

Comentarios a estos manuales

Sin comentarios

Server Technology PT40 Especificaciones Pagina 37

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Server Technology PT40